- Products
- >
- DIY (Do-It-Yourself)
- >
- DIY Connectors
- >
- DIY 1.27mm Pitch 2-Pin Wire-to-Wire Connector (2-Pack)
DIY 1.27mm Pitch 2-Pin Wire-to-Wire Connector (2-Pack)
SKU:
DIY12-2PIN-2PK
$13.49
$6.99
$6.99
On Sale
Unavailable
per item
We needed very small wire-to-wire connectors for some of our DIY projects, so we designed these. Wire-to-wire connectors in a small size are very difficult to find and tough to make, so we're offering these in packs of two for anyone in need of a compact, reliable connection of two conductors for any electronics project.
NOTE: These are sold in packs of two complete sets (two male plugs and two female plugs).
The connectors are very small—the pin spacing is just 1.27mm, which is half the standard connector pin spacing of 2.54mm. See the product photos for size comparisons and measurements in Imperial and Metric units.
Each connector is pre-soldered, secured with internal glue to protect the wires, and covered with heat-shrink tubing. A white polarity dot has also been added so you can make sure cables are connected correctly.
Each connector has 12" (30.4cm) cables of 32 Gauge twisted wire that is tough but also highly flexible. The ends of the wires have been stripped but not tinned. The wires are rated for 1A at 5V DC.
These are great for any robotics or DIY project where you need quick connect/disconnect ability.
NOTE: This is a Do-It-Yourself (DIY) product, and requires soldering to use.
The connectors are very small—the pin spacing is just 1.27mm, which is half the standard connector pin spacing of 2.54mm. See the product photos for size comparisons and measurements in Imperial and Metric units.
Each connector is pre-soldered, secured with internal glue to protect the wires, and covered with heat-shrink tubing. A white polarity dot has also been added so you can make sure cables are connected correctly.
Each connector has 12" (30.4cm) cables of 32 Gauge twisted wire that is tough but also highly flexible. The ends of the wires have been stripped but not tinned. The wires are rated for 1A at 5V DC.
These are great for any robotics or DIY project where you need quick connect/disconnect ability.
NOTE: This is a Do-It-Yourself (DIY) product, and requires soldering to use.